7/20/2023 0 Comments Estlcam keep motors on![]() ![]() ![]() any faster on feed rate and the wobble is exponentially worse. I probably didn’t wobble on this one due to the fact it wasn’t cutting much material.įeed rate is 100mm/m, spindle speed is unknown. the move towards the top and went deeper and wobbled.ģrd is best I have so far, but I’d like to to be a little deeper so the rest of my attempts ended in failure so far. The first pic is last 2 failures do to wobble and one decent one which was the 4th attempt the rest didn’t go so well.ġst one is just awful… it wobbled so much.Ģnd one started fine in the lower right corner. I’m usually close enough to hear the machine running if I do leave to go to the bathroom or kitchen. ![]() I definitely would never start a program and drive off somewhere or go to sleep when working with wood. I was joking about throwing it out but i was pretty frustrated. ![]()
0 Comments
Leave a Reply. |